hi everyone..glad to have found this forum...i have a question for some of you more avid mopar fans out there..& feel lik ethis will no tbe my only post...
 my 1996 jeep has the 318 in it..& ive been trying to get i tto run a little better ..i had lack of power so i changed the fuel filter used injector cleaner...
changed my rotor distributor...(bronse) & wires...but when i finished the wires rotor & distr job...it started bu tshut off immediatelly..like it wouldnt keeps its idle...im in the process of verifying the firing order..but im pretty sure i did it right..but just never know...once it warms up...it keeps a better idle but still too low ..the plugs arent very old..less than a year..plus i cleaned them out a few weeks ago...
i do work in dusty areas..& just replaced a faulty air filter gasket at the same time as i did the wire job.. it was working fine before all this work .. if anyone could tell me what the firing order is....that would be greatly apreciated... any help or advise will be of help...thanx & take care  

Did you plug every thing back in? and tight?